Despatch MIC1462 Controller Manual Uživatelský manuál stáhnout pdf (Strana 17)

2.5 Input Connections

In general, all wiring connections are made to the instrument after it is installed. Avoid

electrical shock. AC power wiring must not be connected to the source distribution

panel until all wiring connection procedures are completed.

Caution: This equipment is designed for installation in an enclosure which

provide adequate protection against electric shock. Local regulations regarding

electrical installation should be rigidly observed. Consideration should be given

to prevention of access to the power terminations by unauthorized personnel.

Power should be connected via a two pole isolating switch (preferably situated

near the equipment) and a 1A fuse, as shown in Figure 2-7.

FIGURE 2-7

Line Supply

The instrument will operate on 90-264V AC 50/60 Hz electrical line supply. The power

consumption is approximately 4 VA. If the instrument has relay outputs in which the

contacts are to carry line voltage, it is recommended that the relay contact line supply

should be switched and fused in a similar manner but should be separate from the

instrument line supply.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

Žádné komentáře

Despatch MIC1462 Controller Manual Uživatelský manuál Strana 17