Despatch Protocol Manager with Protocol Plus Uživatelský manuál stáhnout pdf (Strana 51)

Protocol Manager Software E-100

The junction boxes are used to provide a drop from the network cable to each Oven.

The cables marked "To Oven Controller" are each terminated with a 9-pin Male

subminiature "D" plug, for mating with the Oven Controller's serial data receptacle. Wire

the drop cable according to the following table:

Oven

Signal

Junction Box

Terminal

9-Pin Plug

Pin Number

Rcv +

Rcv -

Xmit +

Xmit -

Gnd

The daisy-chain and drop cables may use shielded pairs. Cable shields should be

connected as follows:

At the B&B adapter B to the earth ground terminal

At each junction box B to the box interior chassis

At each drop cable 9-pin plug B to the plug shell, if conductive; do not

connect to anything if a non-conductive shell is used

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 57

Žádné komentáře

Despatch Protocol Manager with Protocol Plus Uživatelský manuál Strana 51