Despatch Protocol Plus Controller (Heat Only) Uživatelský manuál stáhnout pdf (Strana 35)

Protocol Plus Owner’s Manual OPERATION

Version 2 35

means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and

retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.

Menu Item

Display

Description

Range

Power fail

recovery

Control PwrFRec

Controls response to loss of

power

Stop, Restart, Hold, Resume

Recovery

time limit

Control PFRTime

Control aborts to Stopped

mode if power is lost for time

period longer then set value

00m00s to 99m59s

Powerup

start

enable

ControlPwrUpStrt

Allows mode to automatically

start when power is first

applied

Disable, Enable

Powerup

Start Mode

Control StrtMode

Operating mode for powerup

start

Off, Manual, Timer, Pro-1 to Pro-8

Hysteresis

Control

Hysteresis

Hysteresis for all alarms and

temperature events

1°C to 56°C (1°F to 100°F)

Process

out low

Control

RetOutLo

Process value for retransmit

output = 1VDC

-73°C to 760°C (-100°F to

1400°F)

Process

out high

Control RetOutHi

Process value for retransmit

output = 5VDC

-73°C to 760°C (-100°F to

1400°F)

Time scale

Control

TimeScale

Time scale setting for program

and timer mode

hh:mm or mm:ss

Key press

beep

Control KeyBeep

Internal beeper sounds when

key is pressed

On or Off

End of

cycle beep

Control

EOCBeep

Internal beeper sounds at end

of cycle

On or Off

Alarm beep

Control

AlarmBeep

Internal beeper sounds for

alarms

On or Off

5.6.8. Setting up the Communication Page

The Communication Page contains parameters for the communications feature. Table 7

shows the menu items available.

5.6.8.1. Access Communication Page

1. Enter Setup Mode.

2. Press

Page until Communication displays.

3. Press Menu.

If the display does not change, the controller does not have the

communication board installed.

4. Change each parameter by pressing Menu until the desired parameter is displayed,

and then press ▲ or ▼ to change the value.

Power fail recovery time limit is always MM:SS regardless of time scale setting

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

Komentáře k této Příručce

Žádné komentáře

Despatch Protocol Plus Controller (Heat Only) Uživatelský manuál Strana 35

Komentáře k této Příručce

Související produkty a manuály pro Kontrolní panel Despatch Protocol Plus Controller (Heat Only)