Despatch Protocol 3 Controller Uživatelský manuál stáhnout pdf (Strana 32)

WORKING WITH OPERATING MODES Protocol 3 Controller Owner’s Manual

32 Version 1.2

means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and

retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.

Table 12. Profile Setup Steps, Options and Descriptions.

Step #

Protocol 3 Descriptor

Option

Description

General Configuration

Remote Profile Control

Disabled

Disallow a remote source to run a profile

Enabled

Allow a remote source to run a profile

Automatic Start

Disabled

Disallow use of delayed start time

Enabled

Allow controller to start at a later time with

programmed delay

Create a Profile

Enter a Profile Name

Unique name for each profile using up to 8

characters

Profile Start Trigger

None

Profile start not delayed

After Delay

Set hours and minutes to delay before

starting the profile

Day and Time

Set time of day (hour and minutes) and day

of week to start profile. Options include

each day of the week and combinations of

days.

Profile Recovery

Method

If power-down occurs while this profile is

running, specify the action for the controller

to take during power-up:

Control Off

Controller goes to OFF

Restart Profile

Controller restarts current profile

Maintain Last

Profile SP

Controller maintains previous profile

setpoint

Continue

Profile

Controller continues (for specified time) the

profile from where it was when power

failed.

Profile Abort Action

If program aborts, profile should:

Control Off

Controller goes off

Maintain Last

Profile SP

Choose the number of times to cycle the

program, up to an infinite number of times.

Edit a Profile Segment

Edit Segment Number

Ramp Time

 Set target setpoint (degrees centigrade)

 Set the segment ramp time (hh:mm:ss)

 Set the Auto-Hold Type: None, Above

Setpoint, Below Setpoint, Band.

 Set Events 1-5: Press or to

toggle between Active and Inactive.

Ramp Rate

 Set the target setpoint (degrees

centigrade)

 Set the segment ramp rate in units per

hour

 Set the Auto-Hold Type: None, Above

Setpoint, Below Setpoint, Band.

 Set Events 1-5: Press or to

toggle between Active and Inactive.

Step

Set the target setpoint (degrees centigrade)

10.

Dwell

 Choose time to dwell at setpoint.

Specify Auto-Hold type: None, Above

setpoint, Below setpoint, Band

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 68 69

Komentáře k této Příručce

Žádné komentáře

Despatch Protocol 3 Controller Uživatelský manuál Strana 32

Komentáře k této Příručce

Související produkty a manuály pro Kontrolní panel Despatch Protocol 3 Controller