Despatch Protocol Manager with Protocol 3 and Protocol Plus Uživatelský manuál stáhnout pdf (Strana 27)

Protocol Manager Instruction Manual INSTALLATION & SETUP

Version 1 27

means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and

retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.

Table 4. Protocol 3 Controller Recipe Editor Fields and Descriptions.

Field

Description

Parameters

Recipe

Name

Name of new recipe

being created

Defaults to “NEW.” Replace with desired name.

Seg #

Shows the number

of the profile

segment being

created

From 1-255

Type

Set the segment

type.

 Ramp Time: time to reach target SP

 Ramp Rate: rate of change towards target SP

 Step: jump to target SP

 Dwell: keep current SP

 Hold: hold the profile until released

 Loop: back to previous segment

 Join: join to another profile)

 End :end the profile

 Repeat Sequence Then End: repeat a sequence of joined

profiles—of which this is the last

 A Join, End or Repeat

 Sequence Then End will become the last segment in the profile

Time

Desired Time

HH:MM:SS

Seg/Pr #

Seg: Segment

number used with

the Loop command

Pr#: Profile number

used with the Join

command

Use “Seg” to identify the segment to return to when using the Loop

command.

EV1

Events turn on for

the duration of the

segment.

For End Segments, the event state persists until another profile

starts, the user exits from profiler mode, or the unit is powered down.

EV2

EV3

EV4

EV5

Times To

Cycle

Program

Enter the number of

times to run the

complete program

From 10

Profile

Start

Trigger

Instruction to begin

the selected profile.

 From: None (profile start is not delayed);

 After Delay or Day and Time

Profile

Recovery

Method

The power-on action

if profile was running

at power-down (for

example, after a

power cut), or

following correction

of a signal break.

From: Control outputs off; Restart profile; Maintain last profile

setpoint; Use controller setpoint; Continue profile from where it was

when power failed.

Profile

Abort

Action

Action after profile is

forced to stop before

its end.

From: Control outputs off; Maintain last profile setpoint or Use

controller setpoint.

OPEN

Opens a recipe

saved to the host

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 57 58

Komentáře k této Příručce

Žádné komentáře

Despatch Protocol Manager with Protocol 3 and Protocol Plus Uživatelský manuál Strana 27

Komentáře k této Příručce

Související produkty a manuály pro Kontrolní panel Despatch Protocol Manager with Protocol 3 and Protocol Plus