Despatch Protocol Manager with Protocol 3 and Protocol Plus Uživatelský manuál stáhnout pdf (Strana 31)

Protocol Manager Instruction Manual INSTALLATION & SETUP

Version 1 31

means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and

retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.

Table 5. Protocol Plus Controller Recipe Editor Fields and Descriptions.

Field

Description

Parameters

Recipe

Name

Name of new recipe being created

Defaults to “NEW.” Replace with

desired name.

Seg #

Number of profile segment being created

From 1 to 8 segments are

available.

Ramp Time

Time required to ramp setpoint to temperature

 Enter values between 0 and

99:59

 Units are set locally at each

controller as either hours

and minutes (HH:MM) or

minutes and seconds

(MM:SS).

EV1

Events 1-4

programmed into the Ramp Time

portion turn on for the duration of the segment.

EV2

EV3

EV4

Soak

Temp

Temperature for segment

 Enter values between -18 to

Note that these relays will actuate only when the controller has the relay cards installed and programmed

for an event.



Incompatible Link to Profile Option Message

The Link to Profile value STBY (Standby mode) can

only be used with Protocol Plus controller version 4 or

higher. If a recipe with Standby mode selected is

chosen for download to an earlier-version controller,

Protocol Manager displays this message:

The downloaded profile Link to Profile is set to HOLD

for that controller.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 57 58

Komentáře k této Příručce

Žádné komentáře

Despatch Protocol Manager with Protocol 3 and Protocol Plus Uživatelský manuál Strana 31

Komentáře k této Příručce

Související produkty a manuály pro Kontrolní panel Despatch Protocol Manager with Protocol 3 and Protocol Plus